المنتدى العام المشاركات المختلفة في كافة المجالات ...

الرئيسيــــة استرجاع كلمة المرور دليـل الموقــع أكواد الألــوان

إضافة رد
 
أدوات الموضوع انواع عرض الموضوع
منتديات ساسو سوفت - Sasosoft Forums
قديم منذ /28-09-2019, 07:29 PM   #1

كمال رامي
 
الصورة الرمزية كمال رامي

:: عضو فعال ::

كمال رامي متواجد حالياً

 رقم العضوية : 70540
 تاريخ التسجيل : 21 - 12 - 2018
 المشاركات : 497
 النقاط : كمال رامي is on a distinguished road
 تقييم المستوى : 10

افتراضي ورسان الثانية دبي إصلاح غسالة

<*iv align="left">Warsan Secon* Dubai Washing Machine Repair



Washing Machine Repair - How To Fix Your Washing Machine DIY

Washer troubleshooting an* repair: Here are a few tips on what coul* be going wrong or why your washing machine is broken an* how you can fix it. All of these troubleshooting metho*s can be applie* to washing machines ma*e by Whirlpool, Maytag, Samsung, LG, Kenmore, Bosch, GE, an* more. See below for 6 easy repair metho*s for all washer troubleshootingwater not filling, makes noises, not starting, leaking water, moving an* vibrating, an* *etergent not going into washer.
[فقط الأعضاء المسجلين والمفعلين يمكنهم رؤية الوصلات . إضغط هنا للتسجيل]




[IMG]http://www.m9c.net/uploa*s/15696802373.jpg[/IMG][فقط الأعضاء المسجلين والمفعلين يمكنهم رؤية الوصلات . إضغط هنا للتسجيل]
Repair 1: Washing Machine Is Not Running - Not Starting
If your washing machine refuses to start, it might not be properly connecte* to the power source.
However, if it stops running in the mi**le of a cycle, the machines overloa* protector might have trippe*.
The easiest fix is to take out some of the loa* from the machine an* run it again.

  1. Check the power cor*, the source of power an* electrical supply, if your washing machine refuses to start.
  2. It is also possible on some washer mo*els with knobs, that the on an* off knob might not be working.
  3. Remove power, remove panel, an* check wiring or burnt spots on main control assembly/knob.
  4. You can purchase a new washing machine knob or main control assembly if this is your issue.
Repair 2: Washer Is Taking Too Long To Fill Up With Water
The washtub of your washing machine shoul* take only few minutes to completely fill up before starting the spin cycle.
However sometimes you may notice that your washtub is just taking too long to fill up completely.
Here's what might be happening an* how to fix it:

  1. The valves that control the amount of water filling the washtub might not be completely open.
  2. In this case, you can simply physically check this valve an* make sure that the lever is completely turne* on.
  3. The hoses bringing the water into the washtub might be blocke* or clogge* or the hoses are *amage* an* nee* replace*.
  4. In this case, you nee* to straighten out any kinks in the hose pipe.
  5. Switch off your washing machine an* remove the hose pipe from its attachment.
  6. Physically straighten out any kinks you might fin*.
  7. If the hose pipe is cracke* or leaking, replace it with a new *rain hose.
  8. It is also possible that the hose pipe is clogge* with *irt an* grime.
  9. Clean out the hose pipe well, removing all the clogging particles, an* attach it back to your washer.
  10. Low water pressure might also be a reason why your washtub is taking too long to fill up.
  11. Ensure that all other water sources of your home are shut an* try washing again.
Repair 3: Washing Machine Is Making Grin*ing Noises
More often than not, overloa*ing your washing machine with more clothes than it can han*le causes this common issue.
This is a pretty stan*ar* fix.

  1. The *rain pump on your washing machine is responsible for *raining out all the water from the tub before the spin cycle begins.
  2. However, if this motor starts to make a grin*ing noise, it might in*icate that the *rain pump is *efective or has a restriction.
  3. Remove the front panel of your washing machine an* verify that the source of the noise is from the *rain pump.
  4. Remember that you have expose* the open parts of the washing machine.
  5. Be very cautious while *ealing with an open washing machine.
  6. Remove the inlet hose from the *rain pump, keeping a container han*y to catch any excess water from the *rain pump or hose.
  7. Inspect the pump to see if it is turning properly without any restriction.
  8. Check to see if any foreign objects are lo*ge* in the pump.
  9. Remove any foreign objects or restrictions from the *rain pump, or purchase a new *rain pump if require*.
Repair 4: Washing Machine Is Leaking Water
Water leaking from washer machines is most commonly cause* by hoses or connections that have broken, cracke* or become loose.
  1. Make sure that the water leak is not occurring from a backe* up stan*pipe or a leaking hose pipe, which *rains the water from the water tub.
  2. Check all the hoses an* connections carefully an* look for any cracks, loose en*s, or breaks in these connections.
  3. You coul* buy a hose clamp or even completely replace the hose an* buy a new one.
  4. If you are overusing *etergent in your washing, it coul* be causing some leakage.
  5. To fix this, you coul* opt for a low su*sing *etergent or just put in less the next time you *o your laun*ry.
  6. A loose tub seal or gasket coul* also cause water leaks in your washing machine.
  7. Replace the tub seal of your washing machine to fix this.
Repair 5: Washing Machine Is Abnormally Moving/Vibrating/Shaking:
Washing machines usually come with a shock absorber that *ampens the movement when it is running.
However, a weakene* or *amage* shock absorber will cause unnecessary moving an* shaking of your washing machine.
If this is not correcte* at the earliest, it coul* cause a lot more *amage to your washing machine.

  1. The suspension an* tub springs are in charge of stabilizing the tub to the base.
  2. These springs also absorb the shock an* re*uce the movement of the washing machine while it is spinning.
  3. If these springs become inelastic or *amage*, it coul* be causing unnecessary vibrations.
  4. Replace the suspension springs with new ones an* your washing machine will work as goo* as new.
  5. Many mo*els of washers also have *amper pa*s an* snubber rings locate* at the bottom of the machine.
  6. With normal wear an* tear, these parts also loosen up, causing the washing machine to shake uncontrollably.
  7. An anti-vibration *amper pa* an* a new snubber ring is the perfect fix to this problem.
[فقط الأعضاء المسجلين والمفعلين يمكنهم رؤية الوصلات . إضغط هنا للتسجيل]






  رد مع اقتباس
إضافة رد

مواقع النشر (المفضلة)

الكلمات الدلالية (Tags)
الثانية, غسالة, إصلاح, ورسان

أدوات الموضوع
انواع عرض الموضوع

تعليمات المشاركة
لا تستطيع إضافة مواضيع جديدة
لا تستطيع الرد على المواضيع
لا تستطيع إرفاق ملفات
لا تستطيع تعديل مشاركاتك

BB code is متاحة
كود [IMG] متاحة
كود HTML معطلة

الانتقال السريع

المواضيع المتشابهه
الموضوع كاتب الموضوع المنتدى مشاركات آخر مشاركة
إصلاح غسالة في أبو ظبي كمال رامي المنتدى العام 0 28-09-2019 05:13 PM
النصر دبي إصلاح غسالة كمال رامي المنتدى العام 0 28-09-2019 04:43 PM
سيمنز غسالة إصلاح أبو ظبي كمال رامي المنتدى العام 0 21-09-2019 02:03 PM
هالة وشيرين ورزان..ثلاث مطلقات في بيت العيلة! waleed منتدى الفنون والإبداع 0 02-06-2009 01:55 AM
هالة وشيرين ورزان..ثلاث مطلقات في بيت العيلة! waleed منتدى الفنون والإبداع 0 02-06-2009 01:44 AM

RSS RSS 2.0 XML MAP

الساعة الآن 01:46 AM.


Powered by vBulletin Version 3.8.8
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd

جميع المشاركات المنشورة فى المنتدى لا تعبر عن وجه نظر الإدارة

Please dont post any copyrighted materials like cracks , serials , nulled products .. ETC