المنتدى العام المشاركات المختلفة في كافة المجالات ...

الرئيسيــــة استرجاع كلمة المرور دليـل الموقــع أكواد الألــوان

إضافة رد
 
أدوات الموضوع انواع عرض الموضوع
منتديات ساسو سوفت - Sasosoft Forums
قديم منذ /01-10-2019, 07:34 PM   #1

كمال رامي
 
الصورة الرمزية كمال رامي

:: عضو فعال ::

كمال رامي غير متواجد حالياً

 رقم العضوية : 70540
 تاريخ التسجيل : 21 - 12 - 2018
 المشاركات : 501
 النقاط : كمال رامي is on a distinguished road
 تقييم المستوى : 11

افتراضي لإصلاح الغسالات في دبي

<*iv align="left">Al Quoz Thir* Dubai Washing Machine Repair



A Complete Gui*e to Repair Washing Machine PCB
Steps to Repair Washing Machine PCB
Let'a give you the step by step instructions on it!

  1. It is to be mentione* that in the starting the front loa*er washer must be empty before you can open the *oor to work on it. You nee* to make sure all screws an* components are tight. For the information of the rea*ers, we woul* like to mention that washing machine is all known as the big tub that repeate*ly fills with water an* then *rains. It *oes spins to wring clothes *ry. It also accompanies the *evice for stirring the contents up that is either an agitator in the mi**le of a top-loa* machine or a rolling *rum in a front-loa*ing machine.
  2. After it, the four cycles in the washing machine will be performing the task of the fill, wash, *rain, an* spin. These functions are basic in any washing machine so there are a few numbers of things can go wrong with them. [فقط الأعضاء المسجلين والمفعلين يمكنهم رؤية الوصلات . إضغط هنا للتسجيل]
  3. If the washer *oes not operate or make any noise when set on any cycle, then it is possible that it is not receiving electrical power.
  4. If the washing machine stoppe* at the time when it has to be continue* on to the next cycle, then the machine's overloa* protector may have trippe*. You have to out some of the articles to re*uce the loa* an* let the protector reset itself. After it, you can restart the machine.
  5. You have to make sure the machine is plugge* in an* turne* on. If not, then you have to check the receptacle as it has to be plugge* into for power. This can be all *one as by using a working lamp, or the appliance, or voltage tester. You *o nee* to make sure that the washer li* is close* completely.
  6. If in the con*ition the receptacle seems *ea*, then you shoul* check the circuit breaker or the fuse that serves it.
  7. You shoul* also check the power cor*. You have to unplug the washer an* then check its cor* as in favor of the break or fraye* area. If you *o fin* it important then you can replace the cor*. [فقط الأعضاء المسجلين والمفعلين يمكنهم رؤية الوصلات . إضغط هنا للتسجيل]
  8. You have to open with the li* an* then check the li* switch an* the tab on the li* that it pushes as against. You have to press an* release the switch. If still, it is not working then it means that it has been broken. You shoul* remove the switch, test it, an* replace it if nee*e*.
  9. If the washer still *oes not work, the controls may be the fault in it. You shoul* take help from the appliance repair person.

If you want to prevent some of the problems of the washing machine, then you shoul* follow up with some of the best maintenance proce*ures.
You shoul* make the use of the right amount of *etergent for your washer an* your water har*ness. You *o nee* to make sure the machine is level, an* *on't overloa* it.




[IMG]http://www.m9c.net/uploa*s/156968023810.jpg[/IMG]
What to *o if Washing Machine Does Not Rinse Correctly?
If there is some resi*ue that is on your clothes or in the washing machine following a cycle, then this can be because of so many reasons. First of all, you have to make sure that you are using the machine properly.
You shoul* be putting the right amount of soap in the loa* an* not be overloa*ing the machine. This is for the reason that the overly bulky loa* can cause improper rinsing.
If these types of issues are not lea*ing to any problem, then there are chances that the water is not getting into the *rum or is not *raining out properly. You shoul* be checking the supply valves. [فقط الأعضاء المسجلين والمفعلين يمكنهم رؤية الوصلات . إضغط هنا للتسجيل]
You shoul* make sure the water supply valves that serve the supply hoses are open all the way. You shoul* also make sure that the supply hoses are not kinke*.
You can also give a check on the *rain hose to make sure the machine is *raining fully.





  رد مع اقتباس
إضافة رد

مواقع النشر (المفضلة)

الكلمات الدلالية (Tags)
لإصلاح, الغسالات

أدوات الموضوع
انواع عرض الموضوع

تعليمات المشاركة
لا تستطيع إضافة مواضيع جديدة
لا تستطيع الرد على المواضيع
لا تستطيع إرفاق ملفات
لا تستطيع تعديل مشاركاتك

BB code is متاحة
كود [IMG] متاحة
كود HTML معطلة

الانتقال السريع

المواضيع المتشابهه
الموضوع كاتب الموضوع المنتدى مشاركات آخر مشاركة
المزهر الثانية لإصلاح الغسالات في دبي كمال رامي المنتدى العام 0 29-09-2019 02:31 PM
أبو هيل لإصلاح الغسالات في دبي كمال رامي المنتدى العام 0 28-09-2019 07:48 PM
جبل علي النخلة لإصلاح الغسالات كمال رامي المنتدى العام 0 26-09-2019 10:57 PM
البرشاء الثالثة لإصلاح الغسالات في دبي كمال رامي المنتدى العام 0 21-09-2019 06:10 PM
أم الشيف دبي لإصلاح الغسالات كمال رامي المنتدى العام 0 21-09-2019 01:22 PM

RSS RSS 2.0 XML MAP

الساعة الآن 01:17 AM.


Powered by vBulletin Version 3.8.8
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd

جميع المشاركات المنشورة فى المنتدى لا تعبر عن وجه نظر الإدارة

Please dont post any copyrighted materials like cracks , serials , nulled products .. ETC