المنتدى العام المشاركات المختلفة في كافة المجالات ...

الرئيسيــــة استرجاع كلمة المرور دليـل الموقــع أكواد الألــوان

إضافة رد
 
أدوات الموضوع انواع عرض الموضوع
منتديات ساسو سوفت - Sasosoft Forums
قديم منذ /12-10-2019, 07:03 PM   #1

كمال رامي
 
الصورة الرمزية كمال رامي

:: عضو فعال ::

كمال رامي غير متواجد حالياً

 رقم العضوية : 70540
 تاريخ التسجيل : 21 - 12 - 2018
 المشاركات : 497
 النقاط : كمال رامي is on a distinguished road
 تقييم المستوى : 10

افتراضي نخلة جميرا دبي لتصليح الغسالات

<*iv align="left">Palm Jumeira Dubai Washing Machine Repair



Common Problems
This troubleshooting article or gui*e is meant as a general gui*eline to the most common problems that people are face* with on front loa*ing washing machines. In it we will explain the most frequently aske* questions (FAQs) in relation to washing machines an* washer *ryers but it is a generic article that can apply to almost any front loa*ing washing machine an* not to any specific mo*el.
Checking the simple things can often save you a lot of time an* money as well as give us much more to go on if you still cannot solve the problem an* ask for help in our forums so, please take the time to check the simple things first.
If you're not sure or start to feel that you are out your *epth, get an engineer!
Always remember, safety first an* wherever possible remove power from any washing machine BEFORE un*ertaking any repairs on it
[فقط الأعضاء المسجلين والمفعلين يمكنهم رؤية الوصلات . إضغط هنا للتسجيل]






[IMG]http://www.m9c.net/uploa*s/15705693611.png[/IMG]




[فقط الأعضاء المسجلين والمفعلين يمكنهم رؤية الوصلات . إضغط هنا للتسجيل]
My washing machine is not spinning
Most not spinning issues can be relatively easily cure* as many are *own to either the use of the washing machine or relatively simple faults.
The first an* most obvious things to check are: Are you trying to spin small loa*s? All mo*ern machines have what are calle* out of balance sensors. These sensors (usually built into the electronics) will interpret small loa*s as a potential risk as the washing machine or washer *ryer coul* spin out of balance lea*ing to excessive vibration, potential *amage to the cabinet an* stress on the bearing an* *rum.
Washing small loa*s or single items will often cause this problem.
A*just the loa* an* retry.
The same problem can occur if you put too much laun*ry in the washing machine as well. Is the washing machine *raining correctly? If the washing machine or washer *ryer cannot *rain then it will not spin for safety reasons. Check that the pump is clear by checking the fluff filter if there is one or *isassemble an* check the pump which is always at the bottom of the machine, usually at the front. Are the ca rbon brushes worn? Often, where a carbon brush motor is use*, as the brushes wear *own the motor will start to lose performance turning more slowly than woul* normally be expecte*. Often it is a case of simply removing the carbon brushes an* replacing them with new ones.
My washing machine won't *rain
Don't panic if the washing machine is full of water an* will not *rain, it's pretty easy to get most of them *raine* *own an* open.
The har* part is getting the machine out of situ an* into a position where you can get it *raine* if there isn't an emergency *rain *own facility.
The easiest way to *rain the washing machine if it's full of water is to pull it out an* then *rop the *rain hose into a basin, gravity will *o the rest. This is commonly known as gravity *raining.
My washing machine is reporting a fault co*e
A fault co*e, usually *isplaye* by way of either a seemingly meaningless letter an* number combination or a series of flashing lights (LEDs) is inten*e* to offer service personnel an insight to the nature of the problem. They *o not pinpoint the fault an* are not a replacement for *iagnostic skills.
What they will *o is point to the general area of the fault but it is very worthwhile taking the time to check that you have a goo* water supply an* the filter is clear etc. before you *eci*e to go further or call an engineer.
Fault co*es are very varie* from manufacturer to manufacturer an* even from mo*el to mo*el so there is little else that can be offere* as general a*vice other than it is worth searching the forums for reports of similar fault co*e reports.
Most mo*ern washing machine an* washer *ryer mo*els use such fault reporting.
My washing machine *rum won't turn at all
There are a number of things that can cause this.
Worn brushes, belt problem, faulty motor, faulty motor controller an* so on an* it will take a bit of investigation to narrow *own the cause of the issue.
My washing machine is very noisy
There are three main causes for this:
Something stuck in the *rum, like a bra wire, coin or suchlike "rattling" when the machine is on an* the *rum is moving. Some machines have removable *rum pa**les to allow you access to remove such things but, where there isn't that facility, you can access the offen*ing item very often through the heater hole or the sump hose hole, both you have to remove of course to gain access.
Bearings faile* or failing can also cause a noise. If you turn the *rum by han* an* there is a "rumbling noise" or any play in the *rum up an* *own then it's very probably that the bearings are either faulty or about to be.
Something stuck in the *rain pump, check the filter.
My washing machine bounces about
Check the installation, make sure the machine is level an* any transit straps are remove*.
Other than that, if the machine is a few years ol* check the concrete weights an* also the shock absorbers that connect the *rum to the chassis of the machine.
My washing machine sticks on a part of the program
Or*inarily this woul* in*icate the failure of a component.
If the machine cannot energise or procee* *ue to a problem, for example, the heater *oesn't heat the water so the thermostats *on't tell the controller to a*vance). The trick is to work out what isn't happening that shoul* be an* *iagnosing the fault.
My washing machine *oor won't open
If the machine has water in it or, *etects that there is water in it, the chances are that the *oor lock will not release to prevent any possible safety risk or floo*ing. This is completely normal an* the reason that *oor lock safety *evices are fitte*.
The *oor lock shoul* release as soon as the machine *etects it is safe to *o so.
If this *oesn't happen then it woul* generally in*icate a faulty *oor lock mechanism.
To get the *oor open makes sure that the power is off an* pull the machine out. Get the li* off an*, if you can, reach *own to the *oor lock. You can usually just gently push the latch back to pop the *oor open.
Forcing the *oor to open from the front will result in *amage to the *oor, the latch an* quite possibly the lock an* cabinet
My washing smells really ba*
This has become more an* more common a problem as people use low temperature washes an* liqui* *etergents often without ever running a hot wash. This allows bacteria to buil* up insi*e the washing machine an* eventually thi scoats the insi*e of the outer tank an* causes a horri* smell from your washing machine.
For much more a*vice on this problem an* how to cure it please see this article.
My washing machine will not finish the cycle
In short, almost anything can cause this from motor carbon brushes being faulty, heater, thermostats or almost anything else can cause your washing machine to stop on a program, abort an* *isplay an error of just sit there forever *oing nothing.
Without investigation to fin* out where the machine stops an* why it is impossible to say.
Detergent& Softener Problems
Most of these are usually *own to blocke* jets or *rawers in one way or another but you can learn much more about how they work an* how to solve problems with soap *ispenser *rawers an* fabric con*itioner compartments
[فقط الأعضاء المسجلين والمفعلين يمكنهم رؤية الوصلات . إضغط هنا للتسجيل]





  رد مع اقتباس
إضافة رد

مواقع النشر (المفضلة)

الكلمات الدلالية (Tags)
لتصليح, الغسالات, جميرا, وجلب

أدوات الموضوع
انواع عرض الموضوع

تعليمات المشاركة
لا تستطيع إضافة مواضيع جديدة
لا تستطيع الرد على المواضيع
لا تستطيع إرفاق ملفات
لا تستطيع تعديل مشاركاتك

BB code is متاحة
كود [IMG] متاحة
كود HTML معطلة

الانتقال السريع

المواضيع المتشابهه
الموضوع كاتب الموضوع المنتدى مشاركات آخر مشاركة
دبي لتصليح الغسالات كمال رامي المنتدى العام 0 12-10-2019 06:52 PM
لتصليح الغسالات في دبي كمال رامي المنتدى العام 0 09-10-2019 01:46 AM
لتصليح الغسالات في أبو ظبي كمال رامي المنتدى العام 0 09-10-2019 01:00 AM
لتصليح الغسالات كمال رامي المنتدى العام 0 08-10-2019 01:39 AM
ند شما دبي لتصليح الغسالات كمال رامي المنتدى العام 0 06-10-2019 11:44 PM

RSS RSS 2.0 XML MAP

الساعة الآن 10:33 AM.


Powered by vBulletin Version 3.8.8
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd

جميع المشاركات المنشورة فى المنتدى لا تعبر عن وجه نظر الإدارة

Please dont post any copyrighted materials like cracks , serials , nulled products .. ETC